how to flatten an area ? (for later 2.5D comparsion)

Feel free to ask any question here
Post Reply
andre
Posts: 19
Joined: Wed Mar 08, 2017 5:42 pm

how to flatten an area ? (for later 2.5D comparsion)

Post by andre »

I wish to compare an sloping area to the same volume it would had if it were empty.
started by selecting an area, then cloning it.
How can I flatten the clone to it's outline ? , keeping the outline elevation, and interpolating everything inside should give sort of realistic "ground level" at an sloping angle ... the the two could be compared..
Post Reply