Folks:
I'm trying to run the ICP algorithm in a fully command line mode, but I'm apparently not understanding how to do this. I am running CC command line as follows from the Docker version of CC:
CloudCompare -SILENT \
-O /data/gpfs/assoc/gears/lidarchange/scratch/wscharffenberger/ALS_TLS_UAV ...
Search found 4 matches
- Wed Mar 13, 2019 4:50 pm
- Forum: Questions
- Topic: Headless command line mode?
- Replies: 2
- Views: 4111
- Fri Feb 01, 2019 8:43 pm
- Forum: Questions
- Topic: Does cc support polyline visualization?
- Replies: 3
- Views: 4402
Does cc support polyline visualization?
I was curious: do CC allow the visualization of some sort of 3-d polyline format? If so, what formats are supported? I'm trying to bring a line network into cc to visualize along with a point cloud. Thanks!
- Wed Jan 30, 2019 4:58 am
- Forum: Questions
- Topic: Limiting range of view (dynamically)
- Replies: 1
- Views: 3388
Limiting range of view (dynamically)
Is there a way in CC to limit the distance from the "viewer", basically dynamically slicing based on the viewer location? I want to be able to see e.g. 25 meters but no farther from a camera (so I don't see the more distant points which can cause visualization problems). Thanks!
- Sat Mar 17, 2018 5:46 pm
- Forum: Questions
- Topic: Creating points + measurements
- Replies: 2
- Views: 3094
Creating points + measurements
So we have TLS scans of forests, and what we'd like to do is:
1) Create a "seed point" in the middle of a tree trunk (no points, there is a disk of points around the area we want to place the point)
2) Create an "attribute" table to add data to
3) Have a way to virtually measure the width of the ...
1) Create a "seed point" in the middle of a tree trunk (no points, there is a disk of points around the area we want to place the point)
2) Create an "attribute" table to add data to
3) Have a way to virtually measure the width of the ...