Fill gaps in a point cloud

[un2jay]

hello,

I'm trying to fill in gaps in a point cloud data. is there a tool i can use in Cloud Compare to do this?
Here is an example of how the hole looks like.

[daniel]

I searched for 'fill gaps' on the forum and found: https://www.cloudcompare.org/forum/view ... 593#p26593

[DA523]

You can use same polyline to trim new pointscloud generated by sampling poission mesh
If you need more control of hole (gap) closing , Blender can help a lot
please check attached bin CC file
..

1.png (108.34 KiB) Viewed 10440 times

2.png (167.94 KiB) Viewed 10440 times

3.png (209.83 KiB) Viewed 10440 times

4.png (232.07 KiB) Viewed 10440 times

5.png (324.86 KiB) Viewed 10440 times

6.png (331.5 KiB) Viewed 10440 times

[DA523]

7.png (205.46 KiB) Viewed 10440 times

8.png (229.07 KiB) Viewed 10440 times

2.zip

(130.03 KiB) Downloaded 1072 times

[DA523]

Meshing by simple Delaunay (best fitting plane) is possible too
(meshing, sampling ,segmenting then merging into original pointscloud)
..

[un2jay]

Meshing by simple Delaunay (best fitting plane) is possible too
(meshing, sampling ,segmenting then merging into original pointscloud)
..

Thanks ! This helped a lot :)