CloudCompare forum

Hello,

I've been trying to find a setting that would turn off the "snapping" when I rotate a could in the 3D view.

I hope I am using the correct terminology. So, when I rotate a cloud, using my mouse, if I pass close by the position where it was before I started the rotation, the could will snap into that start position. That's perfectly fine if I am just analyzing the object for myself, but I am also trying to make videos for YouTube.

As a result of this snapping, I don't have a smooth rotation of the 3D object.

Is there a way to turn off this snapping feature?

Daniel suggested to use Animation plugin

Or use the 'Animation' plugin instead? Note that you can also the 'Camera' settings view to finely set the camera position.